Liftoteka lift shaft dimensions and standards for designers
🌐 EN
РусскийEnglish中文Türkçe
Home → Manufacturers → Shanghai Mitsubishi → SM-LEON2V

Shanghai Mitsubishi SM-LEON2V

Home lift LEON-II(V). 0.4 m/s, up to 6 stops, travel up to 15 m. Pit 285 mm, headroom 2,800 (LEON-II-S: 305 and 2,950). Shaft sizes are recommended; minimums are 1480×1400 (centre opening), 1350×1400 (side opening), 1540×1430 (4-panel) — with a smaller car and factory engineering review. 6 sizes, rated load 320–400 kg, machine-room-less (MRL).

Pit 285 mm, headroom 2800 mm. Manufacturer — Shanghai Mitsubishi, China · Shanghai.

Liftoteka is an independent reference. We are not a dealer, representative, authorised partner or service centre of Shanghai Mitsubishi and do not sell this equipment. The name and trademark Shanghai Mitsubishi belong to their owner and are used solely to identify the equipment whose dimensions are listed. Data are taken from the manufacturer's open catalogues.
SeriesShaft clear b3×d2, mmCapacityCar b1×d1, mmHeadroom h1, mmPit d3, mmSpeedClear door opening b2×h3Door typeFound an error?
SM-LEON2V1760 × 1400320 kg · 4 pers.900 × 110028002850.4 m/sper layout sheet2-panel centre openingreport
SM-LEON2V1520 × 1450320 kg · 4 pers.900 × 110028002850.4 m/sper layout sheet2-panel side openingreport
SM-LEON2V1610 × 1430320 kg · 4 pers.900 × 110028002850.4 m/sper layout sheet4-panel centre openingreport
SM-LEON2V1760 × 1400400 kg · 5 pers.1100 × 110028002850.4 m/sper layout sheet2-panel centre openingreport
SM-LEON2V1700 × 1450400 kg · 5 pers.1100 × 110028002850.4 m/sper layout sheet2-panel side openingreport
SM-LEON2V1710 × 1430400 kg · 5 pers.1100 × 110028002850.4 m/sper layout sheet4-panel centre openingreport

Data source: Shanghai Mitsubishi Russian catalogue and factory website. Added to the reference: before 09.09.2026.
If a figure differs from the manufacturer's document, click “report” in the row — an email opens with the model and dimensions already filled in.

Shaft sizes are clear internal dimensions. “Per layout sheet” means the manufacturer does not publish this value in the catalogue and provides it for a specific project.

Updated: 22 September 2026