Liftoteka lift shaft dimensions and standards for designers
🌐 EN
РусскийEnglish中文Türkçe
Home → Manufacturers → PAPPAS Elevators → PAP-HYD-LP

PAPPAS Elevators PAP-HYD-LP

Proton HYD — low-headroom car frame. 0.63 m/s, travel up to 24 m, up to 8 stops. Headroom reduced to 2,400 mm — for when there is little space above the shaft. 8 sizes, rated load 300–1,000 kg, machine-room-less (MRL).

Pit 455–640 mm, headroom 2400 mm. Manufacturer — PAPPAS Elevators, Greece · Athens, Kamatero.

Liftoteka is an independent reference. We are not a dealer, representative, authorised partner or service centre of PAPPAS Elevators and do not sell this equipment. The name and trademark PAPPAS Elevators belong to their owner and are used solely to identify the equipment whose dimensions are listed. Data are taken from the manufacturer's open catalogues.
SeriesShaft clear b3×d2, mmCapacityCar b1×d1, mmHeadroom h1, mmPit d3, mmSpeedClear door opening b2×h3Door typeFound an error?
PAP-HYD-LP1100 × 1725300 kg · 4 pers.900 × 100024004550.63 m/sper layout sheet2-panel telescopic, 1 entrancereport
PAP-HYD-LP1325 × 1800300 kg · 4 pers.900 × 100024004550.63 m/sper layout sheet2-panel telescopic, 2 opposite entrancesreport
PAP-HYD-LP1200 × 1975450 kg · 6 pers.1000 × 125024004550.63 m/sper layout sheet2-panel telescopic, 1 entrancereport
PAP-HYD-LP1425 × 2050450 kg · 6 pers.1000 × 125024004550.63 m/sper layout sheet2-panel telescopic, 2 opposite entrancesreport
PAP-HYD-LP1300 × 2135630 kg · 8 pers.1100 × 140024004550.63 m/sper layout sheet2-panel telescopic, 1 entrancereport
PAP-HYD-LP1535 × 2200630 kg · 8 pers.1100 × 140024004550.63 m/sper layout sheet2-panel telescopic, 2 opposite entrancesreport
PAP-HYD-LP1600 × 23751000 kg · 13 pers.1400 × 160024006400.63 m/sper layout sheet2-panel telescopic, 1 entrancereport
PAP-HYD-LP1875 × 24001000 kg · 13 pers.1400 × 160024006400.63 m/sper layout sheet2-panel telescopic, 2 opposite entrancesreport

Data source: dimension tables on the Proton mRL and Proton HYD pages of pappaslift.gr (checked 18.09.2026). Added to the reference: 18.09.2026.
If a figure differs from the manufacturer's document, click “report” in the row — an email opens with the model and dimensions already filled in.

Shaft sizes are clear internal dimensions. “Per layout sheet” means the manufacturer does not publish this value in the catalogue and provides it for a specific project.

Updated: 22 September 2026