Liftoteka lift shaft dimensions and standards for designers
🌐 EN
РусскийEnglish中文Türkçe
Home → Manufacturers → PAPPAS Elevators

PAPPAS Elevators lifts: shaft dimensions

Greece · Athens, Kamatero. 5 series, 46 sizes. Rated load from 300 to 1,275 kg, shaft width 1100–2000 mm, depth 1600–2830 mm.

Liftoteka is an independent reference. We are not a dealer, representative, authorised partner or service centre of PAPPAS Elevators and do not sell this equipment. The name and trademark PAPPAS Elevators belong to their owner and are used solely to identify the equipment whose dimensions are listed. Data are taken from the manufacturer's open catalogues.

About the manufacturer

PAPPAS Elevators, Athens, Kamatero district, 18A Sokratous Street. Exports to 23 countries, over 150 employees, its own PIC innovation centre of 2,500 m² — according to the company, the first development centre in Greece created exclusively for lifts.

THE MAIN DIFFERENCE. According to the manufacturer, the Proton mRL series is the only one on the world market delivered pre-assembled, fully tested and commissioned before shipment to site. The wiring is done at the factory: plug-in, colour-coded connections, no wires to terminate on site, no special tools; the control station and shaft wiring are assembled by an ordinary installation crew. For regions without a strong manufacturer supervision service this removes the main risk — installation error, on which, as the factory itself writes, the safety and operation of the lift depend 100%.

The sizes in the tables are minimums. The factory explicitly states that other combinations are possible and that its engineers should be consulted for the optimal car-and-shaft combination. The door width is not given in the open tables: only the type is stated — two-panel telescopic doors located in the shaft. Quick car calculation for mRL-470: car width = shaft width minus 470, depth = shaft depth minus 350 for a single entrance and minus 580 for two opposite entrances. For the rucksack frame the width deduction is 530 or 590 depending on the version. The standard car floor is a wear-resistant anti-slip rubber covering.

NOTE: EU origin. Direct supply to Russia is restricted and in practice goes through third countries; confirm the HS code status, lead time and TR CU certificate holder with the broker and the supplier before signing.

Questions about the brand — info@liftoteka.ru.

Series

PAP-MRL470Proton mRL-470 — passenger, machine-room-less · 16 sizesPAP-MRLLProton mRL-L — rucksack frame, machine-room-less · 8 sizesPAP-HYDProton HYD — hydraulic, standard car frame · 8 sizesPAP-HYD-LPProton HYD — low-headroom car frame · 8 sizesPAP-HYD-LPHProton HYD — low-pit and low-headroom car frame · 6 sizes
All dimensions are taken from the manufacturer's catalogue. Before issuing working drawings, request the manufacturer's layout sheet for the specific project — the layout changes with the number of stops, counterweight position and door type.

Updated: 22 September 2026